Non-Programmable Thermostat for Home Single-Stage Systems, 1 Heat/1 Cool, Easy DIY Install, Blue Backlight
$23.99
Related Products
Product description
STN601-Blue
STN601-Blue
Simple thermostat for home,room temperature controller,temperature regulator for heating and cooling,house furnace,gas fireplaces,AC unit,millivolt control panel,temperature switch,non programmable thermostat,push button wall thermostat DIY,hvac fan
High Compatibility: Forced air (gas, oil or electric), Electric furnace, Hot water steam or gravity radiant heat, Heat only systems, Heat pump w/o auxiliary or emergency heat, Millivolt, Gas fireplaces (24V), Floor or wall furnaces, Cool only systems.(TIP: Before purchasing, check to see if this thermostat is compatible with your system.)
Not Compatible: Heat pump with auxiliary or emergency heat, Dual fuel/hybrid heating, Electric baseboard heat (110-240 volts), Line voltage, Convectors, Radiant-ceiling heat, Mini split systems and 12V RV systems.
Easy to Install and Use: Large terminal blocks with universal sub-base, can be installed within 30 minutes, clear, easy-to-read backlight LCD display and easy controls make for a user-friendly experience.
Simple but Powerful Control: Easy-access front-load battery compartment, adjustable temperature differential (swing) for energy optimization and maximum system life, Support temperature display calibration, Convert °C/°F units, compressor delay protection (selectable on or off).
Dual Power Supply: Can be powered by 24VAC power or 2 AAA batteries, No common wire (C-wire) required on most systems (only required on heat only and cool only systems).
11 reviews for Non-Programmable Thermostat for Home Single-Stage Systems, 1 Heat/1 Cool, Easy DIY Install, Blue Backlight
Add a review
$23.99
AngelRedHawk –
Great value& Easy to follow instructions
Perfect for folks like me. Too poor to hire an electrician to replace a thermostat. The directions are easy to follow. There are stickers to put on the wires as you disconnect them(VERY USEFUL!) I bought the green because ‘blue light is bad at night’. Mine is battery operated, but can’t use rechargeable batteries. (My ONLY complaint) Works JUST FINE with my 25 year old furnace. Batteries have lasted for 4 months so far because the screen is not backlit unless you press a button( which will change the temp you want, just change it back when you’re done) I was scared to try to install a new thermostat on my own. This made it easy! Cold weather is here and I am warm. TG
Nigel R. Guest –
Performs exactly as described
I initially ordered two programmable thermostats. One turned out to be for baseboard heaters (do they still exist?) and the other one’s programming was impossibly complex and poorly documented, so both orders were canceled/returned. As I’m retired and live in a Mediterranean climate, I wouldn’t benefit from complex settings anyway (time of day, weekends, etc), so I decided to keep life simple and bought this. It was easy to install and works perfectly. It even has limited setting adjustments – room temperature calibration, setpoint and hysteresis (temperature difference between on and off).
Danni Akers –
Nice, accurate, very adaptable, easy to install thermostat.
This seems to be a nice, easy to operate, accurate, adaptable thermostat. The installation and wiring were a breeze and the screw holes in the base of the thermostat lined up perfectly with my old Carrier thermostat holes, so no drilling for me. Just some touch up paint since this thermostat is slightly smaller than my old one. I’ve added some scans of the installation manual showing the wiring schemes and the procedures for adjusting the differential and calibrating the temperature reading. Out of the box, the heating differential is 0.4 deg F and cooling differential is deg 0.5 F. To clarify, this means the heat when set to 65 deg F, for example, it will turn on when the temp drops to 59.6 deg F and turn off when the temp rises to 65.4 deg F. You can set the differential as low as 0.2 deg F and as high as 2 deg F. The calibration of the unit, out of the box, was spot on to my traceable thermometer, so no adjustment needed there, but it is easily done. It is important to note, that in order to preserve batteries, you really need to connect the common (if available) from the 24VAC transformer to C terminal on the thermostat. Otherwise, the thermostat and its internal circuitry (it has at least one internal relay for example) will be powered by the batteries only, 24/7. The batteries probably won’t last very long operating in this configuration.Additionally, don’t forget to set the GAS/ELEC fan mode switch on the back of the thermostat before snapping the thermostat into place on the base during installation. In the GAS mode, the thermostat will not independently turn on the blower fan when the demand for heat signal is sent. In the ELEC mode the thermostat will turn on the fan (via green wire) at the same time the heat demand signal is sent. The default, out of the box, position of this switch is GAS.
Samuel Dawood –
Price is right
Works great you can see the numbers from a distant very bright and accurate arrived on time. It’s perfect for eyesight
Elizabeth I –
Make sure you get batteries
Ok first I probably should of read that it doesn’t come with batteries so make sure you get AAA batteries. The batteries do not fit tightly which is why it is only a 4 star review. It is easy to install and only took me 15min, take pictures of where your wires go or use the labels that are included. Works great for the 2 wire system that’s in older houses like mine.
Matt –
Good replacement
Works great,and easy to install
Jackye Valley –
Good value and quality
Nice , neat looking unit. Easy to install. Great value
Kirsti –
Great product
Easy installation and works great.
Reg Stranks –
very good and easy to install
Jack Howton –
works great
Dan kelly –
Easy install and works well. The display does not light up so kind of hard to see especially at night.